DC JOLLY SLIM LED DRIVER 47VDC 350-900MA 32W 237X30X21MMDIMBAAR 1-10V & PUSH

JOLLY SLIM 1…10 V & PUSH
Direct current dimmable electronic drivers multivoltage-multicurrent for power LED and LED modules

Driver for built-in use.
• Multi-power driver supplied with dip-switch for
the selection of the output current
• Active Power Factor Corrector.
• Light regulation 0-100% by means of PUSH
function (L mains voltage: 170 Kohm):
- a short push to turn on and off;
- a longer push to increase or decrease light
intensity;
- regulation automatically stops at minimum and
maximum values;
- for another on, regulation or off command,
release the push button and give the desired
command again.
• Maximum length of the cable, from push button
to last driver, must be max. 15 m.
In case of applications where the cable is longer
than 15 m, keep this separate from the
110-240 Volt mains cable.
• Synchronization cable supplied separately.
• Max. 10 drivers synchronization, is possible
command only one driver (1Master + 9Slaves).
• ATTENTION: only use normally open push
buttons with no incorporated warning light.
• Light regulation 0-100% by means of PUSH
function, 1...10 V interface (I=0,35 mA) or
100 Kohm potentiometer (1...10 Vdc source with
double or reinforced insulation with respect to AC
mains). For regulations see page 104-105.
• Current regulation ±5% including temperature
variations.
• It can be used for lighting equipment in protection
class I and II.
• Ultra compact size.
• Driver can be secured with slot for screws.
• Protections:
- against overheating and short circuits;
- against mains voltage spikes;
- against overloads.
• IP67 cover available upon request
(code 180066/390).
•Can be switched on and off on secondary
circuit for power LED.