DC MAXI JOLLY HC LED DRIVER 26-44VDC 1050-2010MA 55W 110X76X30MM DIMBAAR 1-10V & PUSH

Direct current dimmable electronic drivers multicurrent for power LED and LED modules

Driver for built-in use.
• Multi-power driver supplied with dip-switch for
the selection of the output current.
• Active Power Factor Corrector.
• Light regulation 0-100% by means of PUSH
function (mains voltage):
- a short push to turn on and off;
- a longer push to increase or decrease light
intensity;
- regulation automatically stops at minimum and
maximum values;
- for another on, regulation or off command,
release the push button and give the desired
command again.
• Maximum length of the cable, from push button
to last driver, must be max. 15 m.
In case of applications where the cable is longer
than 15 m, keep this separate from the 240 V
mains cable.
• Possibility to use PUSH function to 4/5 drivers
without sync cable.
• Synchronization cable supplied separately.
• Max. 10 drivers synchronization, is possible
command only one driver (1Master + 9Slaves).
• ATTENTION: only use normally open push
buttons with no incorporated warning light.
• Light regulation 0-100% by means of PUSH
function or Interface 1...10 V (1...10 Vdc source
with double or reinforced insulation with respect to
AC mains). For regulations see page 104-105.
• Current regulation ±5% including temperature
variations.
• It can be used for lighting equipment in protection
class I and II.
• Input and output terminal blocks on the same
side (terminal area 2,5 mm2).
• Driver can be secured with slot for screws.
• Protections:
- against overheating and short circuits;
- against mains voltage spikes;
- against overloads.
• Thermal protection = C.5.a.
•Can be switched on and off on secondary
circuit for power LED.
• Auxiliary output 12 V max. 100 mA.
• Analogical input for thermal sensor connection.